地址：广州市番禺区石基镇富怡路傍江东村段439-4号
手机：13427689370（陈工） 13427689308（程工）
专注于直流伺服电机,行星减速器,直流无刷电机的生产和销售!
备案：粤ICP备15022410号-2 SEO：18网络 技术支持：九鑫传媒
- 1
- 2
- 3
- 4
- 5
南阳市德马克电机有限公司
地址：广州市番禺区石基镇富怡路傍江东村段439-4号
手机：13427689308（程工）
手机：13922312579（凌工）
微信：13828402501（杨工）
SQT91139-48V80A
Lower voltage High temperature resistant hall-less induction driver pecification
一、功能特点Feature：
● 无感控制Sensorless control
● 过压欠压保护、过流保护、过热保护 Protection beyond the scope of power supply voltage\
overload protection\over-temperature protection.
● 报警Various alarm instructions
● 外部电位器调速speed regulation by External potentiometer
● 外部模拟信号调速speed regulation by External analog signal
● PWM控制调速speed regulation by PWM signal
● 报警后自动复位、重启Automatic reset and restart after alarm
二、技术参数Technical specification
Project | Min value | Typical value | Max value | Unit |
Input voltage | 8 | 48 | 60 | V |
Output current | -- | 50 | 80 | A |
Speed control | 300 | 3000 | 4000 | Rpm |
Size | 154*105*45MM | |||
Ambient temperature | -20 | 90 | ℃ | |
Speed control mode | 1: 0-5VDC analog input 2: 0-100% duty cycle PWM input (PWM Frequency domain: [1Kz-20KHz) 3: External potentiometer speed control | |||
二、端口描述Port definitions：
Port definitions | Specification | |
VCC | Power connection | Power supply positive electrode(8v-60v) |
GND | Power supply negative electrode | |
U | Motor connection | Motor line U phase |
V | Motor line V phase | |
W | Motor line W phase | |
VDD | control single | The positive pole of potentiometer |
VS | Speed regulation signal input | |
COM | The negative pole of potentiometer | |
EN | Speed feedback signal output | |
RVS | Potentiometer,reserve(Apply to function extensions) | |
FG | Output single | Work enable input, connect COM port to work |
ALM | Alarm signal output | |
Red light | indicator light | Alarm indicator，synchronized with ALM signal |
Green light | Power on indicator | |
三、调速说明：Speed regulation description:
Mode 1：Add 0V-5V analog signal to port VS for speed regulation
Mode 2：Add 0%-100% duty cycle PWM signal to port VS for speed regulation,PWM Frequency domain: 1Kz-20KHz
Mode 3：Add potentiometer to port VDD VS COM for speed regulation,10K is recommended for potentiometer.
四、速度反馈说明：
Port FG is Speed signal feedback,
For 8-pole motors, FG frequency * 30 = current speed.
For 4-pole motors, FG frequency * 60 = current speed.
五、保护及报警Protection and alarm
1、堵转保护、缺相保护，电机被卡死堵转或电机线断开一路则停机报警，红灯快速连续闪烁；
1. Locked rotor protection, motor disconnection protection, if the motor is stuck or the motor line is disconnected, the motor will stop and give an alarm, and the red light will flash quickly and continuously;
2、过流保护，当工作电流大于设定电流则停机报警，红灯每间隔1秒闪1下；调速信号归零后恢复。
2. Overload protection: when the working current is greater than the set current, stop the motor and give an alarm, and the red light flashes once every 1 second; After the speed regulating signal returns to zero, the motor returns to normal operation.
3、过热保护，当电路板温度大于设定温度则停机报警，红灯每间隔1秒闪2下；调速信号归零后恢复。
3. Over temperature protection: when the temperature of the circuit board is greater than the set temperature, the motor will stop and give an alarm, and the red light will flash twice every 1 second; After the speed regulating signal returns to zero, the motor returns to normal operation.
4、过压欠压保护，当供电电压超出范围则停机报警，红灯每间隔1秒闪3下；调速信号归零后恢复。
4. protection beyond the scope of power supply voltage，when the power supply voltage exceeds the range, the motor will stop and give an alarm, and the red light will flash 3 times every 1 second; After the speed regulating signal returns to zero, the motor returns to normal operation.
四、装配孔位图Assembled drawing：
Top view of assembly drawing：
Unit：mm 16 mounting holes, diameter: 3.1mm
五、外部防护Shell and joint description：
1.铝合金散热型外壳Aluminum alloy heat dissipation shell
2.格兰头防水端子Waterproof connection port
3.驱动器电机联接端口Drive controller connection port
